What stepper motor to use in heated chamber this thread.
What stepper motor to use in heated chamber
"Since it has a heating chamber I can't use normal stepper motor" Sure you can, the interior doesn't get all that warm unless you really seal it up tight, and that's not really needed. I have an enclosure around my 200x200x200 mm MIGBOT (early Prusa clone with direct drive extruder), printing PLA with 60 °C bed, the interior only gets a few degrees warmer. The motors can take a lot more heat than you think they can.
I have a couple pictures in this thread.
The front & back panels are 18x24 inch polycarbonate from Home Depot, I 3D printed the corner brackets, and added a couple of pieces of wood for some stiffness. The entire front hinges up. The top is 24x24 inch, and the back 6" hinges up to access the SD card that is on the display/control panel.
Cloudray Stepper Motor Series has set the standard for quality, reliability, and durability in stepping motors. The precision of our Torque Power motors is matched only by the dependability of their performance. All Torque Power motors are bi-directional and totally enclosed with permanently lubricated ball bearings for long-lasting, smooth operation.
Sample Block Quote
Praesent vestibulum congue tellus at fringilla. Curabitur vitae semper sem, eu convallis est. Cras felis nunc commodo loremous convallis vitae interdum non nisl. Maecenas ac est sit amet augue pharetra convallis nec danos.
Sample Paragraph Text
Praesent vestibulum congue tellus at fringilla. Curabitur vitae semper sem, eu convallis est. Cras felis nunc commodo eu convallis vitae interdum non nisl. Maecenas ac est sit amet augue pharetra convallis nec danos dui.
Cras suscipit quam et turpis eleifend vitae malesuada magna congue. Damus id ullamcorper neque. Sed vitae mi a mi pretium aliquet ac sed elitos. Pellentesque nulla eros accumsan quis justo at tincidunt lobortis denimes loremous. Suspendisse vestibulum lectus in lectus volutpat, ut dapibus purus pulvinar. Vestibulum sit amet auctor ipsum.