stepper motor nema 34 laser is engraving the negative space
stepper motor nema 34 laser is engraving the negative space
M42
command is an immediate command. This means that it will run before the move GCode commands finish. This is exactly what I was facing.
-
The laser driver requires a 5 volt TTL input control signal. The Marlin fan control Mcodes (M106 and M107) will be used to control the laser .Unfortunately, the Ramps fan output (D9) is a 12 volt signal so we can’t use it. We'll need a quick firmware edit to remap the fan output from pin D9 (12v) to pin 44(5v).
-
Make a backup copy of your Marlin firmware folder first. Open the pins_RAMPS_13.h file in your Marlin firmware folder with a text editor (Wordpad). Search for the line where the fan pin is assigned and change it from pin 9 to pin 44.
-
Save the changes and flash the revised firmware back onto your Mega board.
Cloudray Stepper Motor Series has set the standard for quality, reliability, and durability in stepping motors. The precision of our Torque Power motors is matched only by the dependability of their performance. All Torque Power motors are bi-directional and totally enclosed with permanently lubricated ball bearings for long-lasting, smooth operation.









Sample Block Quote
Praesent vestibulum congue tellus at fringilla. Curabitur vitae semper sem, eu convallis est. Cras felis nunc commodo loremous convallis vitae interdum non nisl. Maecenas ac est sit amet augue pharetra convallis nec danos.
Sample Paragraph Text
Praesent vestibulum congue tellus at fringilla. Curabitur vitae semper sem, eu convallis est. Cras felis nunc commodo eu convallis vitae interdum non nisl. Maecenas ac est sit amet augue pharetra convallis nec danos dui.
Cras suscipit quam et turpis eleifend vitae malesuada magna congue. Damus id ullamcorper neque. Sed vitae mi a mi pretium aliquet ac sed elitos. Pellentesque nulla eros accumsan quis justo at tincidunt lobortis denimes loremous. Suspendisse vestibulum lectus in lectus volutpat, ut dapibus purus pulvinar. Vestibulum sit amet auctor ipsum.